Wiring Material: amp

Showing posts with label amp. Show all posts

Tuesday, September 16, 2014

Regulator power supply with op amp

Power supply circuit has a first amplifier using op-amp is IC uA741. Op amp circuit that is used only one, but it also features an adjustable voltage, which is steered by a trimpot resistors. Rtrim will set the input to the IC input on pin 2, so that if the detainee on Rtrim which will be channeled into ic enlarges the output voltage will be small, and otherwise. After the voltage is boosted and filtered and then the voltage will be regulated and boosted again by a NPN transistor.

Output voltage 0.5V - 35V

Part List :
Resistor
R1____1K5
R2____1K trim
R3____10K
R4____330R
R5____1K
R6____47R
R7____68R
R8____820R
R9____47K
R10___22K
R11___1K5

Capacitor
C1____10000uF 80V

Transistor
Q1____2N3565
Q2____2N3565
Q3____S9013
Q4____S9013

Diode
D1____1N4007
D2____1N4007
LED1_Red Led

IC
U1____uA741 (op-amp ic)

Wednesday, September 10, 2014

Simple Subwoofer Lowpass Filter using uA741 Single Op Amp Ic

This is the simplest Sub woofer Low Pass filter Circuit using uA741 single op amp ic. The schema is very low cost with respect to their work. The cut off frequency of this schema is 25Hz to 80Hz maximum. Using this schema , you can easily design a 2.1 Sub-woofer Speaker System at your own Home. The schema contains very few components.In Pakistan, the cost of this schema with PCB is Rs:45 The same schema is working in my own hand made sub-woofer system. So Try this [Link]

Parts List:

R1,R3,R4 = 10K 1/4W
R2=100K 1/4W
CY1,CY2 = 0.22uF Polyester
C1,C2 = 10uF/25V Electrolytic
IC1 = uA741A Single Op-Amp Ic + 8 Pin Ic Socket
3 Pin Male & Female Connector x 2
2 Pin Male & Female Connector x 1
PCB as in required size 4.5 cm x 3.4 cm